Router 2.00mm x 8.00mm

£3.80
(Exc. 20% VAT)
(£4.56 Inc. VAT)
In stock
+
Model
02112
Brand
Union Tools
Printed circuit boards are usually made of fiberglass (FR4), which is highly abrasive and given the many hundreds or thousands of holes on modern circuit boards, requires the use of specialist tools. PCB Supplies supply the highest of quality Tungsten Carbide contour routers.

We hold stock of SC/FT Series Routers; these Routers have a right hand, up draft design which lifts debris upwards out of the hole being drilled rather than allowing it to fall into the hole causing the bit to bind and break. These Routers also feature a chip-breaker geometry, this chops the swarf into smaller parts and helps to reduce the radial load on the spiral flute this reducing bird nesting and binding and general wear producing more accurately cut, cleaner edged holes.

The SC/FT Series Routers are suitable for peripheral contour routing. This series have a beneficial effect on burr reduction.

Depth Setting Rings

We recommend that bits are fitted with depth setting rings. This will allow you to set the plunge depth stop on your drill press to a single value that will work for all bit diameters.

All of our bits can be purchased with or without rings. When ordering drills with depth rings, you may specify the depth ring position to suit your requirements.