Shop by Brand

EM1001 Basic Programmable Ethernet Board

EM1001 Basic Programmable Ethernet Board
Our Price:  £25.00(Exc. 20% VAT)(£30.00 Inc. VAT)

Part Number:  02989
Brand:  TIBBO



In stock


The EM1001 is Tibbo's most powerful and versatile BASIC-programmable Ethernet board. The EM1001 is a close relative of the EM1000 Ethernet module. Two devices have the same feature set, including the 10/100BaseT Ethernet port, four serial ports, onboard flash disk, EEPROM, and the RTC with optional backup supercapacitor.

Like the EM1000, the EM1001 board can control the GA1000 Wi-Fi add-on, as well as an external LCD, keypad, buzzer, and many other peripheral components.

Unlike the module, the EM1001 is a self-sufficient board: it has a 12V-to-3.3V switching power regulator, RJ45 connector with magnetics, three LEDs, and the MD button. Thus, the EM1001 does not require a host board to plug into. The EM1001 is the host board.

As such, the EM1001 is equally suited to low-volume production devices and hobbyist projects alike.


  • Based on high-performance purpose-built 88MHz T1000 IC.
  • 10/100BaseT auto-MDIX Ethernet port with RJ45/magnetics.
  • Four high-speed serial ports (CMOS-level):
    • Baudrates of up to 921,600bps;
    • None/even/odd/mark/space parity modes;
    • 7/8 bits/character modes;
    • Full-duplex mode with optional flow control;
    • Half-duplex mode with direction control;
    • Encoding and decoding of Wiegand and clock/data streams.
  • 1024KB flash memory for firmware, application, and data.
  • 2KB EEPROM for data storage.
  • RTC with an optional backup supercapacitor.
  • Supports external LCD and keypad.
  • Programmable square-wave output for external buzzer.
  • Up to 54 general-purpose I/O lines (including 8 interrupt lines).
  • Three onboard LEDs:
    • Red and green status LEDs;
    • Yellow Ethernet status LED.
  • Two control lines for externally connected LEDs.
  • Software- and hardware-controlled onboard PLL.
  • Reliable power-on/brown-out reset circuit.
  • Powering options:
    • Through the switching power regulator with 8-20V input range;
    • Using regulated 3.3V power (the regulator is bypassed).
  • The regulator can provide up to 1.3A of 3.3V power to external devices.
  • Power consumption: 250mA @ 3.3V (100BaseT mode, PLL on).
  • Dimensions: 75x36x17.5mm (not including RJ45, power jack, GA1000).
  • Firmware is upgradeable through the serial port or network.